| Hello. If you have a Sonicview 360 ELITE and no USB | | | | 14) You will see a large list, the only things you should |
| stick this is the tutorial that you should follow in order | | | | change are Satellite, make sure LNB power is ON and |
| to get your unit back up and working. | | | | DISEQ Port |
| You can get all of the files below at our FTA FORUM | | | | 15) select your first Satellite, usually its Echostar 7 or |
| you will need the latest FTA KEYS 1) Download the | | | | 8, select either of these |
| Loader program here | | | | 16) now select your DISEQ switch, put it on DISEQ |
| 2) Download the most recent Bin file - | | | | Port 1 |
| 3) Download WINZIP here | | | | 17) you should now see your signal and quality up to |
| 4) Now, UNZIP the loader to your desktop | | | | around 80% or higher, if this is the case, you have |
| 5) In the same directory you copied your LOADER | | | | now setup your first satellite. |
| to unzip the latest BIN file | | | | 18) press the red button on your remote to SCAN |
| 6) Hook up via serial cable your Sonicview 360 | | | | your satellite, you should start seeing channels being |
| Premier to your computer | | | | scanned, if you dont't repeat process 15-18, but use |
| 7) Once your premier is hooked up to your computer | | | | DISEQ Port 2 Instead of 1 |
| click on STB/CONNECT | | | | 19) Once both your Satellites are configured, lets say |
| 8) It will ask you to allocate a COM port, try COM 1, | | | | echostar 7 on DISEQ Port 1 and Echostar 8 on |
| it will either say success or fail, if fail try COM 2, then | | | | DISEQ port 2, and both satellites are scanned turn to |
| Com 3, until it says, success | | | | channel 200 (cnn) and let the keys roll. |
| 9) Then click on STB/Download file/Select file, load | | | | This is the process that you should be doing, this is |
| the most recent BIN File to your receiver (note, the | | | | the exact step by step process to get your |
| bin file again should be in the same directory as the | | | | Sonicview 360 Premier or 360 ELITE to work if you |
| Loader Directory) | | | | do not have a USB FLASH drive. |
| 10) Bingo, you have now loaded the BIN file to your | | | | I hope the members of GoodFTA find this tutorial |
| Receiver | | | | Useful, this tutorial is 100% orginal Content for our |
| 11) Unplug the premier from your computer back to | | | | members at GoodFTA. |
| your TV | | | | If you have any questions regarding this thread, |
| 12) with the remote, select main menu, or press the | | | | please ask them here, do not reply to anything on |
| little button directly to the LEFT of the BIG button | | | | this thread unless it is a specific question about one |
| beside your USB drive in the front. | | | | of the steps. |
| 13) Select Installation/Dish setting, press OK | | | | |